step speed
Used to set the axis speed for the jog and move commands. The speed is specified as slow, medium (med), or fast. The actual values for the F, R, and S speed parameters are taken from the STEPsubsystem NVS parameters.
If no speed is specified, the current speed settings are displayed:
Initial speed (designated 'F') in the range 1 to 254, where a higher value indicates faster speed.
Final speed (designated 'R') in the range 1 to 254, where a higher value indicates faster speed.
Acceleration (designated 'S') in the range 1 to 254, where a higher value indicates faster acceleration.
The step axes can be referred to by either name or number. The following list shows the name, number, and location of each step axis in the autoloader subsystem.
3 pz picker z-axis
4 py picker y-axis
5 ty turtle y-axis
6 tw turtle w-axis
7 uz unload table z-axis
8 lz load table z-axis
9 ux unload table x-axis
Platesetter_VLF
step <axis> speed [slow|med|fast]